Dukane DPC II Plus Manuel d'utilisateur télécharger pdf (Page 2)

- 2 -

22102

AN200

Rev 01

Dukane Corporation

2900 Dukane Drive Saint Charles, IL 60174 USA

Phone (630) 797-4900 FAX (630) 797-4949

http://www.dukane.com/us

Intelligent Assembly Solutions

System Input Connector

The System In interface connector is one of the primary communications links between the DPC II / II+ input port and

the user automation equipment. This connector provides the automation with dedicated communication lines that

allow the automation to control the beginning and the end of a welding sequence.

Pin Number DPC Signal Name DPC Signal Type

1 Power Su

+22 VDC

(

250 mA max

)

2 Ground 22VDC Return

3 Isolated O

erate In

ut In

4 Isolated In

ut Common

Common for

in 3, 5, 9

5 Isolated Press Control

6 Not Used Not Used

7 Ground +22VDC Return

8 Non Isolated O

erate In

9 Isolated Automation Stop /

Automation End of Weld

Input

10 Not Used Not Used

11 Hand Probe Press Inhibit In

12 MPC Probe/Setu

Bit 0

13 MPC Probe/Setu

Bit 1

14 MPC Probe/Setu

Bit 2

15 Front Panel Control Lock In

Notes:

1. SH707 on the 110-3606 system I/O PCB must be configured to the JU728 position when this

common is used.

2. This input requires the optional 110-3938 press control module. Configuration of the SH901

Jumper on the 110-3938 press control module may also be required.

3. This input is configured for use as Automation End of Weld at the factory. Jumper SH704 must

be reconfigured on the 110-3606 System I/O board to permit use of the Isolated Automation

Stop feature.

4. The MPC probe bit functionality requires the optional MPC feature. The Setup bit functionality

is available on all DPC II+ systems. Please refer to the DPC manual for further details on this

feature.

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

Dukane DPC II Plus Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage Dukane DPC II Plus